Listening To A Non-Docking Ipod Or Other Portable Audio Device; Maintaining Your Speaker System - Altec Lansing iMT620 Guide D'utilisation

If you have a non-iPod MP3 player or other non-docking portable audio
device, you can enjoy it through your Altec Lansing inMotion Classic
speaker system as well. Just connect it via the AUX jack. Here's how:
1
Locate a 3.5 mm stereo cable
(not included).
2
Plug one end of the stereo cable
into your device.
Your device should have either a
headphone or LINE OUT jack for you
to plug into.
3
Plug the other end of the stereo
cable into your speaker system's
AUX jack.
The AUX jack is located on the back
of the unit.
4
Select "AUX" mode.
Press the "SOURCE" button on your
speaker system or the full-featured
remote until "AUX" appears on the
speaker system's LCD.
5
Turn on your device and start it playing.
6
Adjust the volume.
Use the "+" and "–" buttons on the speaker system or full-featured
remote to adjust the volume.
You may need to adjust the device volume also. Your device's
NOTE
volume should be set to approximately ¾ volume.

Listening to a Non-docking iPod or Other Portable Audio Device

7
When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off
to conserve electricity.

Maintaining Your Speaker System

Place your speaker system on a level surface away from sources of direct
sunlight or excessive heat.
Protect your furniture with a cloth or other protective material when placing
your speaker system on a natural wood or lacquered finish.
Clean your speaker system with a soft cloth moistened only with mild soap
and water. Stronger cleaning agents, such as benzene, thinner or similar
materials, can damage the surface of the unit.
15