Switching Off And Disconnecting The Appliance; Cleaning The Appliance - Siemens KF W Série Mode D'emploi

Switching off and
disconnecting the
appliance
Switching the appliance off
Fig. 2
Press the main On/Off switch 1 (red
circle becomes visible).
Temperature display goes out. Fridge
and light are switched off.
Disconnecting the appliance
If you do not use the appliance
for a prolonged period:
1. Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Clean the appliance.
4. Leave the appliance door open.

Cleaning the appliance

ã=
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers
■
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out mains plug or switch off fuse.
3. Wait until the layer of frost has thawed.
4. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light or through
the drainage hole into the evaporation
area.
5. Wipe the door seal with clear water
only and then wipe dry thoroughly.
6. Rinsing water must not run through
the drainage hole into the evaporation
area.
7. After cleaning reconnect and switch
the appliance back on.
Note
Regularly clean the condensation
channel and drainage hole, Fig. 3, with
a cotton bud or similar implement
to ensure that the condensation can
drain.
en
21