Assembly/Adjustments; Unfolding; Folding; Attaching The Bag - Bischoff & Bischoff Alevo Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Alevo
| Rollator

4. Assembly/adjustments

4.1. Unfolding

Position the rollator in the travel direction.
Release the locking brakes (see sec. 4.6.).
Press the frame tubes of the seat downward to unfold the rollator
(Fig. 4). Make sure the tubes are aligned properly and snap into
4
place.

4.2. Folding

Activate the locking brakes.
Hold the rollator firmly with one hand on the handle. With your
other hand pull the grip on the seat upward (Fig. 5).
When doing so you must overcome the resistance of the locking
5
device.

4.3. Attaching the bag

The rollator is unfolded. Activate the locking brakes.
Position yourself against the travel direction in front of the rollator.
Pull the straps of the bag over the two plastic handles (Fig. 6).

4.4. Adjusting the push handles

6
The rollator is unfolded. Activate the locking brakes.
Hold the push handle firmly with one hand. With the other hand,
activate the locking device (Fig. 7).
Move the push handle to the desired height and let go of the
locking device.
Now move the push handle up and down slightly to ensure that it
snaps audibly into place.
7
Repeat this procedure on the other side.
30
On the inside of the push handles you'll find a scale (Fig. 8), which
you can use to check the height of the handle. Make sure that both
the number and the marking line is visible.
Check to make sure that both the push handles are at the same
height.
Setting the push handle height according to body
height.
Level 0 – 1.59 m (1590 mm) or taller
Level 1 – 1.65 m (1600 mm) or taller
Level 2 – 1.70 m (1700 mm) or taller
Level 3 – 1.75 m (1750 mm) or taller
Level 4 – 1.80 m (1800 mm) or taller
Level 5 – 1.85 m (1850 mm) or taller
Level 6 – 1.90 m (1900 mm) or taller
Use these figures as guidelines; they may vary in practice.

4.5. Adjusting the back strap

To adjust the height of the back strap, the hand screws on the
frame (Fig. 9) must be loosened.
Move the fastener for the back strap to the desired height and re-
tighten the screws.
The fasteners for the back strap should be at the same height on
both sides.
Bischoff & Bischoff GmbH | 17.06.2020 - Revision: 1
Alevo
Rollator |
8
9
31

Publicité

Table des Matières
loading

Table des Matières