Husqvarna LE121P Manuel D'utilisation page 10

1. Raise the lower handlebar.
2. Assemble the upper handlebar with the lower
handlebar. Tighten the knobs.
3. Move the knobs to the lower end of the grooves on
the two sides of the product.
4. Set the handle height in one of the 2 available
positions.
10
5. Move the knobs up in the direction of the handle until
they stop and you hear a click.
CLICK!
6. Tighten the knobs fully on the two sides of the
product.
7. Put the wires in the cable brackets. Make sure the
wires are not twisted. Attach the cable brackets to
the handlebar.
8. Use a cable tie to attach the cables to the handlebar
bracket.
428 - 002 -