Esoteric UX-1 Manuel Du Propriétaire page 17

Q DISPLAY
Use this button to change the display mode.
R FL DIMMER button
Use this button to change the brightness of the front panel
display.
S
REPEAT
Use this button to set the repeat playback mode.
T
PROGRAM
Use this button when programming playback order.
U
GROUP/TITLE
Use these buttons to skip back or forward by one group or
title.
V
SKIP (.//)
These buttons are equivalent to the skip buttons on the front
panel.
W
PAUSE
This button is equivalent to the PAUSE button on the front
panel.
X TOP MENU
Use this button to return control to the top menu of a DVD.
Y RETURN
Use this button to go up a level in menu systems. When
playing back video CDs, use it to return to the top menu.
Z SUBTITLE
Use this button to select the displayed subtitles during DVD
playback.
a
ANGLE
Use this button to select camera angles during DVD playback.
How to insert the batteries
Remove the cover of the remote control unit with a
screwdriver. After checking the polarity (+/_) of two AA
batteries, insert the batteries, replace the cover and replace
the screws.
Battery Replacement
If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they
leak, wipe away the liquid inside the battery compartment
and replace the batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
Notes on use
< Point the remote control unit at the player's remote sensor
and use it within seven meters' distance of the player. There
should not be any obstacles between the player and the
remote control unit.
< Do not allow direct sun or other light to shine on the remote
sensor part of the player. This may cause the remote control
unit to work incorrectly.
< Note that other units with remote controls may operate
incorrectly because of infrared light "overspill" when you
operate this remote control unit.
17