Water Condensation Drainage - Honeywell HQ09 Série Mode D'emploi

WATER CONDENSATION DRAINAGE

When there is excess water condensation inside the unit, the Honeywell Portable Local Air Conditioner
stops running and shows a warning light (the WATER FULL indicator illuminates with a red light). This
indicates that the water condensation needs to be drained using the following procedures:
Manual Draining for Cooling, Heating* & Dehumidifier Mode
Water may need to be drained in high humidity areas.
1. Unplug the unit from power source.
2. Place a shallow pan under the lower rubber drain plug.
See diagram.
3. Remove the rubber drain plug.
4. Water will drain out and collect in the shallow pan.
5. After the water is drained, replace the rubber drain plug.
6. You can now turn on the unit.
Continuous Draining for Dehumidifier Mode
While using the unit in dehumidifier mode, continuous
drainage is recommended.
1. Unplug the unit from power source.
2. Remove the upper/lower rubber drain plug.
Some residual water may spill so please have a pan to
collect the water.
3. Connect the drain tube (included) to the upper or lower
drain (whichever is more convenient for your space).
4. The water can be continuously drained through the
drain tube into a floor drain or bucket.
5. Replace the drain plug.
6. You can now turn on the unit.
Shallow Pan
(Not included)
EN 11
Upper Rubber
Drain Plug
Drain Tube (included):
Dia. 0.9" (2.2cm)
Length: 29.3" (74.5cm)
*Applicable for models with Heating feature only.
Lower
Rubber
Drain Plug