in-lite LIV LOW Manuel D'utilisation page 4

EN
Contents
1x LIV LOW (DARK) 12 V / 2 W
Dimension Ø 67 mm / 2.6 inches
Height 360 mm / 14.2 inches
1x ground stake
3x screws
3x plugs
1x Easy-Lock
1x Torx key
Material
Aluminium housing
High quality plastic lens
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Use
Above-ground lighting suitable for the yard or to mark a pathway, drive
or patio.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life and a high light output and their power consumption
and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
General Installation Guideline
During installation, make sure that all components are easily
accessible for replacement.
Step 1
The fixture can be mounted on a hard surface using the screws sup-
plied or in soft surface using the ground stake supplied. The ground
stake is easily fixed by screwing it in the underside of the base of the
fixture.
When used on a hard surface first remove the base of the fixture by
loosening the three Torx screws. Next, fix the base to the surface us-
ing the screws supplied and plugs if necessary. (Fig. 1) Then place the
fixture back onto the base and tighten the three Torx screws.
Step 2
Join the Easy-Lock connector to the main cable. (Fig. 2)
a. There are two cable grips. The grip with the wider recess fits the
10/2 main cable, the grip with the narrower recess fits the 14/2
main cable. Clamp the correct cable grip over the main cable.
b. Put the cable grip (with the cable underneath) in the Easy-Lock
connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 3
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 3)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.