Sage BFP800 Guide Rapide page 9

ASSEMBLY
5. Place the processing lid onto the
processing bowl so the feed chute is
slightly right of the bowl handle and the
arrow graphics are aligned
Holding the feed chute and pressing
down fi rmly at the same time, turn the lid
clockwise (as indicated by the graphic)
so the 'Locking Tab' on the lid slots into
the 'Interlocking Safety Catch' on the
handle. The lid should be securely locked
into position.
NOTE
The food processor will not operate
unless both the processing bowl and
lid are correctly locked into position.
CAUTION
The processing blade (including
the mini bowl blade) and discs are
extremely sharp, handle with care
at all times.
6. Insert the power plug into a 220–240 volt
power outlet and switch the power
outlet on.
.
7. At the end of processing, always wait until
the blades or discs have stopped spinning
before unlocking and removing the lid.
To remove the processing lid, ensure the
POWER / OFF button has been pressed,
the power is switched off at the power
outlet and the cord is unplugged from the
power outlet. Holding the feed chute and
pressing down fi rmly at the same time,
turn the lid anti-clockwise so that the
arrow graphics are no longer aligned.
8. Remove the processing bowl (before
removing blade or discs) by turning it
anti-clockwise until the handle is in line
with the ALIGN HANDLE. Lift the bowl
off the motor shaft. When removing the
discs – carefully remove by gripping the
plastic hub on the centre of the disc and
lifting the disc up and away from the pin
on the spindle.
OVERLOAD PROTECTION SYSTEM
If the motor overloads, the food processor will go
to STANDBY mode and OVERLOAD icon in the
LCD starts to fl ash. The food processor can still
be switched off by pressing the POWER / OFF
button. To operate the food processor again,
allow the machine to cool for approx 30 minutes.
Some stiff mixtures, such as dough, may cause
the dough blade to rotate more slowly than
normal. If this happens, do not process for
longer than 1 minute.
EN
9