SEVERIN PG 8546 Mode D'emploi page 14

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
∙ Before the grill is used, always check
that the heating element is correctly
fitted in the housing and grill pan. The
safety switch is activated automatically
when the heating element has been
properly fitted. If it is fitted incorrectly,
the appliance cannot be switched on.
∙ The barbecue grill must be
supervised at all times during
operation.
∙ Always bear in mind that the housing
surfaces as well as the heating element
and the rack become very hot during
operation. Even after the heating
element is switched off, it must not be
touched until it has sufficiently cooled
down - there is otherwise a severe
danger of burns.
∙ Do not allow the power cord to touch
any hot parts of the appliance.
∙ Always remove the plug from the wall
socket
- before filling the grill pan with
water,
- after use,
- in case of any malfunction, and
- during cleaning.
∙ The use of an extension-lead reel
causes a loss of power, possibly
combined with a subsequent heat build-
up in the cable. It is therefore necessary
to unwind the cable completely if a
cable reel is used. Make sure that the
reel is approved for outdoor use by the
manufacturer.
∙ Caution: Do not move the grill when it
is in use. Before carrying, transporting
or storing the grill, ensure that is has
sufficiently cooled down. Pour out any
14
remaining water after use.
∙ Ensure that the grill is not stored
outdoors, or in any other location where
it might be subjected to extremes of
temperature or high humidity.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This barbecue grill is intended
for domestic use only and not for
commercial applications.
∙ This product complies with all binding
CE labelling directives.
Heating element
The junction box contains a safety switch.
Place the heating element into the grill pan.
The safety switch is activated automatically
when the heating element has been
properly fitted. If not fitted correctly, the
appliance cannot be switched on.
Before using for the first time
∙ Remove any packaging materials and
stickers from the appliance.
∙ Clean the rack and grill pan with warm
soapy water; wipe thoroughly dry
afterwards.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pg 8547Pg 8548

Table des Matières