Westfalia 307 260 391 101 Instructions De Montage page 18

Installing the electrical kit
1. Disconnect the negative battery terminal.
2. Remove the spare wheel.
3. Remove the right and left tail light.
4. If necessary, remove the following coverings and panels:
Rear cover on the left inside the luggage trunk
-
Outer edge cover under the left tail light
-
5. Bore a hole with a diameter of 40 mm for the cable leadthrough (Fig. 1/3) in a suitable place
in the area of the lower left vehicle corner.
6. Starting in the luggage trunk, lead the cable end with the socket through the vehicle's cable
leadthrough (Fig. 1/3) to the outside and from there to the socket holder plate (Fig. 1/5).
7. Slip the rubber grommet on the cable harness.
8. Insert the rubber grommet into the cable leadthrough (Fig. 1/3).
9. Fit the socket gasket to the cable harness.
10. Connect the cable harness to the socket housing in accordance with the socket pin
assignment plan (Fig. 1/5) and push the rubber grommet towards the socket.
11. Screw the socket onto the holding plate (Fig. 1/5) using the supplied screws and nuts.
12. Secure the cable harness on the cross-bar using cable ties.
Connecting the trailer module
13. Plug the 12-pin plug into the trailer module.
14. Fasten the trailer module (Fig. 1/1) to the left-hand side of the luggage trunk using some
velcro tape.
15. Connect the brown wires with the eyelet to the vehicle's ground point (Fig. 1/4).
Connecting the back-up light, the brake light and the tail light
16. Connect the back-up light, the brake light and the tail light to the vehicle's lines in accordance
with the pin assignment plan and using the supplied crimp connectors.
Pin assignment plan
gray/black
black/red
gray/red
green
18
Control line for left tail light
Control line for brake light
Control line for right parking light
Control line for back-up light
307 260 391 101 - 005 – 41/09 Ford Transit