Troubleshooting - G-Clean GC141333 Série Manuel D'utilisation

PROBLEM
Pressure washer does
not start when trigger is
depressed
Pump doesn't produce
pressure
Machine doesn't reach
high pressure
No detergent when
using detergent injector
(high pressure)
No detergent when
using detergent injection
hose (low pressure)
Wand leaks

TROUBLESHOOTING

POSSIBLE CAUSE
Power cord not connected to power
source
Switch is off
GFCI is tripped
House/shop circuit breaker is tripped
Inadequate water supply
Spray wand leaks
Nozzle is clogged
Pump is faulty
Air in line
Water inlet filter is clogged or dirty
Hose is leaking
Kink in hose
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Detergent injector is empty
The dial on the detergent injector is set
to water only
Water supply is inadequate or clogged
Mesh filter or G-clean injector intake
ports are blocked
Wrong nozzle is attached to spray
wand
Filter is clogged on injection tube or
tube is not completely submerged in
cleaning solution
Water supply is inadequate or clogged
O-ring needs replacing
Page 15 — English
SOLUTION
Connect the power cord to a live 120V AC, 60
Hz AC receptacle.
Turn switch on.
Press reset button on the GFCI plug.
Reset house/shop breaker. Make sure pressure
washer is connected to an individual branch
circuit only. If using an extension cord, make
sure it is heavy enough to carry the current of
the pressure washer.
Provide adequate water flow.
Check connections and / or replace wand.
Clean nozzle.
Contact authorized service center.
Squeeze trigger on spray wand to remove air
from line.
Remove the water inlet filter, rinse with warm
water, then replace in unit.
Replace hose.
Eliminate kinks in hose.
Replace with 3/4 in. garden hose.
Check garden hose for kinks, leaks, and
blockages.
Open water source full force.
Replace detergent pouch.
Set dial to soap.
Check garden hose for kinks, leaks and
blockages.
Clean the mesh screen and/or check the intake
ports for blockages.
Attach black soap nozzle.
Remove the detergent injection tube inlet filter,
rinse with warm water, then replace. Make sure
tube filter is lying on the bottom of the detergent
bottle or bucket.
Check garden hose for kinks, leaks and
blockages.
Replace o-ring. If this does not correct the
problem, contact your authorized service center
to purchase a new wand.