G-Clean GC141333 Série Manuel D'utilisation page 17

For low pressure cleaning without the detergent injec-
tor:
Use only detergents designed for pressure washers. House-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to
use. Prepare cleaning solution as instructed on the solution
bottle.
 Remove the G-Clean detergent injector from the unit or
place the dial completely clockwise to the water only
position.
 Place the detergent injection tube into the cleaning solu-
tion container.
 Install the black soap nozzle on the spray wand.
 Start the pressure washer and spray the detergent on
a dry surface using long, even, overlapping strokes. To
prevent streaking, do not allow detergent to dry on the
surface.
OPERATION
To rinse:
 If the detergent injector is installed, turn dial completely
clockwise to the water only position. If using the detergent
injection tube, remove from cleaning solution.
 Spray away from the rinsing surface for approximately 10
seconds to allow any remaining detergent to be flushed
from the line.
 Start at the top of the area to be rinsed and work down,
overlapping the strokes.
Before shutting off the motor:
 If using the detergent injection hose, place it in a bucket
of clean water and spray for 1-2 minutes to allow clear
water to flow through the spray wand.
Page 13 — English