Publicité
Les langues disponibles
Les langues disponibles
Visor Installation
Tools Required
Phillips head screw driver, Flat head screwdriver.
WARNING
Make certain power is OFF before starting installation or
attempting any maintenance.
1.
Make certain all power is OFF before starting
installation.
2.
Remove the existing (4) black clips on the edge of the
lens with flat head screwdriver. (Figure 6.)
3.
Insert the accessory spacers over existing holes.
4.
Align visor on top of accessory spacers matching the
(4) existing holes (Figure 9.)
5.
Add (4) 10-24 Philips head screws to the face of the
fixture to tighten the wire guard.
6.
To remove visor follow steps 1-4 in reverse order.
Installation Instructions - NFFLD-S/UFLD-S
(4) Screws
Figure 9.
EATON
IB506003EN
(4) Accessory
Spacers
Visor
Installation instructions
5
Publicité
