Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - NFFLD-S/UFLD-S
INSTALLATION
This lighting fixture has been shipped complete with one
of several mounting options. Please follow the installation
instructions specific to the catalog part that you ordered.
Tools Required
#2 Philips screwdriver, Flat head screwdriver and hex head.
N
ote:
This configuration is provided with a trunnion which
can be mounted directly on a flat surface.
Trunnion Mount (Figure 1.)
1.
Mount luminaire to surface using the hole pattern
provided on the trunnion bracket. Recommend 1/4"-20
lag bolts and washers (supplied by others, tightened to
50-60 in-lbs.).
2.
Loosen but do not remove the (2) set screws and (2)
center bolts.
3.
Adjust the position of the trunnion flood bracket to
desired aiming position. Retighten center bolts and set
screws to 15 in-lbs. Assembly should be rigid for fixture
mounting.
4.
Refer to wiring diagrams for power connection
(Figure 4.)
Tools Required
#2 Philips screwdriver 3/8" square nut driver.
Slipfitter Mount (Figure 2.)
1.
To change luminaire tilt angle, loosen center screw, and
rotate fixture to the desired angle.
2.
Re-tighten screw to 25 in-lbs.
3.
Remove (2) cover screws to access wires.
4.
Route wires through pole into splice compartment.
N
ote:
Ensure wires do not get pinched.
5.
Loosen (3) set screws to secure fixture position
luminaire into the desired direction; retighten the (3) set
screws to 10 ft.-lbs.
6.
Slide the slipfitter onto pole or mounting bracket.
N
ote:
Ensure wires do not get pinched.
7 .
Make wiring connections per wiring diagram and push
connections into splice compartment. (Figure 4.)
8.
Replace cover plate and tighten (2) cover screws to
15 in-lbs.
9.
Tighten lock nuts to 65 in.-lbs.
2
EATON
IB506003EN
Installation instructions
(2) Center Bolt
1-3/8" [35mm]
5" [127mm]
Trunnion Mount Drill Pattern
Figure 1.
Center Screw
(3) Set Screws
Figure 2.
(2) Set Screws
1/2" [13mm]
2-1/4" [57mm]
(2) Cover Screws
(3) Lock Nuts
Publicité
