Metal Works CAT 10090V Mode D'emploi page 13

CAT10090V - NLFRENES - v1.0 - 15082014
EN
1
10
4 Operation
Gebruik
4.1 Stop block
1. The stop block (3) holds the workpiece in place while the selected bending die (17-23) on the handle (9) bends
around the long hitch pin (1) or selected center die.
Long hitch pin (1)
Stop block (3)
Workpiece
Long hitch pin (1)
2. The stop block and center die are secured using two long hitch pins. The bending die is secured using one short hitch
pin (2). The center die is always secured in the outermost holes of both die receivers.
3. The support pin (5) is used to raise the level of the stop block so that it is even with the center die.
4. The stop block must be positioned in one of four ways. Always position the stop block so that it is as close as possible
to the center die, while still allowing for the thickness of the stock.
9
Support pin (5)
Short hitch pin (2)
Bending die
Center die
Stop block - Fig. 4
13
Assembly - Fig. 2
Stop block - Fig. 3
®