Toggling Between Venetian Blind And Awning Mode; Intermediate Position - Becker Centronic VarioControl VC470 Notice De Montage Et D'utilisation

Toggling between venetian blind and awning
Press the programming button for 3 seconds at the master transmitter until the
receiver acknowledges it.
Subsequently press the programming button and additionally the Up/Stop/
Down button for 10 seconds until the receiver acknowledges it.
Toggling has now been completed.
Note
The intermediate position is a freely selectable curtain position, be-
tween the upper and lower end position. The intermediate position can
only be set after the two final positions have been set.
The curtain is adjusted into the intermediate position from the upper
final position.
a) Setting the intermediate position
1. Adjust the curtain from the upper final position to the desired intermediate
position.
2. Now press and hold the STOP button. Within 3 seconds also press the DOWN
button and keep both buttons pressed.
The curtain will "nod" to confirm.
The intermediate position has been stored.
b) Adjusting the curtain to the intermediate position
1. Press the DOWN button twice within one second.
The curtain will move to the intermediate position.
c) Deleting the intermediate position
1. Adjust the curtain to the intermediate position.
2. Now press and hold the STOP button. Within 3 seconds also press the DOWN
button and keep both buttons pressed.
The curtain will "nod" to confirm.
The intermediate position has been deleted.
mode

Intermediate position

de
en
fr
nl
23