Bosch GLM 40 Professional Notice Originale page 30

30 | English
The oldest value is located in position 1 in the memory, while the newest value is in posi-
tion 10 (when 10 memory values are available). If a further value is saved, the oldest
value in the memory is always deleted.
Deleting the memory
To delete the content of the memory, press button (4) [Func], so that the symbol ap-
pears on the display. Then briefly press the on/off button (5) [ ] to delete the displayed
measured value.
If the measuring tool is switched off during the memory function, the memory value
shown on the display will be deleted.
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the section on (see "Area measurement", page 28).
Press the button (6) [+]. The calculated area is shown on the display,
and symbol "+" flashes.
Press the measuring button (2) [ ] to start another area measure-
ment. Measure an area as described in the section on (see "Area
measurement", page 28).
Press button (6) [+] to calculate the sum. The end result is shown at
the bottom of the display.
To exit addition, press the button (4) [Func].
1 609 92A 5DX | (27.01.2020) Bosch Power Tools