Publicité
Les langues disponibles
Les langues disponibles
After fix ing anti-ti t bracket, push the electric cooker inside cabinet as shown in Figure 4. For
l
correct installation, the rear and right foot of cooker would be clipped by the anti-tilt bracket.
•
Electrical connection
WARNING THIS APPLIANCE MUST BE EARTHED.
-
Power supply voltage and frequency:
The electric cooker i s without a power supply cable. The cooker is designed to operate on an
electricity supply which conforms to the electrical data shown on the Rating label The
cooker can be connected to the mains only after removing the back panel of the cooker itself
with a screwdriver.
Note
:
the following installation procedure must be carried out by a qualified electrician.
For the installation of the
1. Open the terminal board by inserting a screwdriver into the side tabs of the power
code cover. Use the screwdriver as a lever by pushing it down to open the cover as below:
mains
cable carry out the following operations:
.
220-240V/380-415V 3N , 50/60 Hz
EN-10
~
.
Publicité
Chapitres
Dépannage
