Publicité
Les langues disponibles
Les langues disponibles
Generator controls:
01. ON/OFF master switch
02. Halogen ON/OFF
03. Halogen 100% ON/OFF
04. Channel I output control
05. Channel I display
06. Channel II output control
07. Channel II display
08. Open-flash / test button / Channel
selection for the RADIO SLAVE receiving
module
09. Optical firing monitor ON/OFF
10. Acoustic signal ON/OFF
11. Slave cell ON/OFF
12. Slave cell
13. Generator handle
14. Sync terminals („Sync-in/-thru")
15. Automatic circuit breaker
16. Power socket
17. Flash socket, channel I
18. Flash socket, channel II
19. Flash socket, channel II
(MAGNOLUX 3600 ONLY)
20. Socket lock
21. Channel I ON/OFF
22. Channel II, ON/OFF
23. Channel II, 2nd flash ON/OFF
(MAGNOLUX 3600 ONLY)
24. LED
25. Channel I /I+II switch
26. LED
27. Socket for LUXREM-R radio receiver
28. SMA-connector for RADIO SLAVE
receiving aerial
29. Control LED, RADIO SLAVE module
Flash-unit controls
28. Pyrex globe
29. Halogen lamp
30. Flash tube
31. Halogen-light ON/OFF
32. Fuse
33. Flash-unit nameplate
34. 5/8" socket
35. Bayonet clamp
36. Umbrella reflector with holder
37. Pyrex-globe clamps
38. Type V reflector bayonet mount
39. Flash plug
40. Tilting mount with clamp
41. Lock screw
42. Flash handle
8
Operating Instructions
Magnolux 1200 - 2400 - 3600
Caution:
Be sure to form the flash capacitors before
using the equipment for the first time as well
as after three months of non-use. To do this,
proceed as follows:
1.
Connect a flash unit to generator chan-
nel I (see section 2)
2.
Set switch (1) to ON.
3.
Use switch (25) to apply full output to
channel I.
4.
Set output control (4) to minimum
output (display (5) showing 1.0).
5.
DO NOT fire the unit!
6.
Leave the unit switched on in this
condition for half an hour.
7.
At intervals of 30 minutes, increase
output by one f-stop until the display
(5) reads power level 5.0.
8.
DO NOT switch on the halogen light for
the entire duration of the forming pro-
cess.
The capacitors are formed after about three
hours, and the unit may be used.
1. Basic equipment
Magnolux generators:
Generator with 5m power cable, 5m sync
cable
Magnolux flash units:
Flash unit with 5m power cable, flash tube,
halogen tube, Pyrex globe, protective cap,
spare fuses.
Standard flash unit:
MALAX-4 up to 4000 Ws
Custom flash unit:
MALAX-24S with ultra-short flash duration.
2. Preparing the equipment for use/
connecting the flash units
Before using the equipment, compare its
nameplate ratings (27) with the data of your
local power supply. The generators have be-
en designed for 220-240V AC/50-60 Hz. A
fuse rating of at least 16 A is required for the
power socket.
Plug one end of the power cable into socket
(16), the other into a wall outlet.
Flash units:
The flash units of the Magnolux Series are
Publicité
