BSVILLAGE 3EXB0195-FRAME Notice De Montage page 2

1.0
SAFETY INSTRUCTIONS: EXTREMELY IMPORTANT!
(a) Read and observe all instructions. Keep this manual for future reference.
(b) Unsuitable for children up to 36 months of age, because small parts could cause suffocation.
(c) WARNING! To reduce the risk of injury, the pool may be used only under a supervision of an adult. Never leave children unattended near water. Do not allow anyone to use the pool while alone,
without supervision.
(d) The installation requires at least two adults.
(e) Persons under the influence of alcohol, drugs or other intoxicating substances may not use the pool.
(f) WARNING! This product is not intended for use in water. Verify the pool is installed on a level and firm surface free of debris and sharp objects.
(g) WARNING! Do not overfill the pool and/or do not let anyone sit, lean or otherwise apply load on the pool's walls - it may cause the pool to collapse! LOWER the water level in the pool appropriately,
especially after heavy rain.
(h) The packaging materials are not toys. After installation, remove all packaging loops/cords from the reach of children.
(i) Please, note: During use, regularly check the pool for wear and damage.
(j) Never leave toys near or inside the pool when unattended. It could attract children to enter the pool.
(k) Around the pool, do not leave steps, tables or chairs, which could make access for children easier. If the pool is not in use, remove the steps.
(l) Never allow swimming underwater and diving into the pool or sitting on its edge. If you disregard this rule, it may lead to serious injury, paralysis or death.
(m) Always place the pool in a well-lit place. It is important, so all swimmers see the bottom of the pool.
(n) If you are using a cover or solar tarp, remove it completely before using the pool.
(o) WARNING! Prior to commissioning the pool, check all hoses and accessories for correct installation and reliable connection.
(p) Maintain the water in the pool in a sanitary condition, regularly check the pH value and correct concentration of chlorine and keep them within the recommended limits. Consult your dealer
regarding the choice and use of chemical preparations for pool water treatment. Read thoroughly the manufacturer's instructions on the labels co chemical preparations and observe them. Inform
the swimmers not to drink the pool water to avoid possible nausea. Maintain hygiene.
2.0
INSTRUCTIONS REGARDING LOCATION
(a) This pool is intended for outdoor use and is not designed for embedding into the ground.
(b) Your pool is a fragile product and can be easily damaged. Pay attention to the selection of pool's location.
(c) The area for the pool must be LEVEL and SOLID. Failure to observe this instruction may cause the collapse of the pool.
(d) The pool must be installed on a solid, smooth and level surface, on solid ground, free of stones, gravel, potholes, asphalt or other oil-based compounds. Do not install the pool on wooden base or
grate, terrace, balcony etc.
(e) Avoid places beneath overhead power lines or close to trees, or within 3 meters from a house, building, terrace etc. Also make sure, that beneath the installation place there are no underground spaces
(sumps, septic tanks etc.) and no cables, phone lines, gas mains etc.
(f) This place must be at least 3.5m from an outlet of the filtration power supply circuit, in compliance with ČSN and fitted with a current protector (RCD) with breaking current not exceeding 30mA.
(g) If possible, select a place on your property with direct sunlight. This will help with warming the water in your pool. Do not pull the pool to another place after you start filling it with water.
(h) Select a place for installation of the pool, where, in case of accident or damage of the pool, water can easily flow away without endangering people and animals or damaging buildings or property.
Failure to observe the instructions in this manual may cause your pool to collapse and the guarantee becoming null!
3.0
CONDITIONS OF POOL INSTALLATION
ATTENTION: Risk of damage! When transporting the pool from one place to another, LIFT it above the ground. DO NOT DRAG the pool over the ground.
After careful selection of a suitable place for the pool, see chapter (2), thoroughly remove all debris, twigs, stones etc. Continue with the installation and observe the following instructions.
(a) Carefully unpack the pool and place it on the ground. Place the pool as needed. Do not drag the pool, it could cause its rupture or other damage.
(b) Carefully spread the pool by folding its walls and the bottom out as smoothly as possible, to create a uniform circle, with the connecting grommets towards the location of the filtration unit.
TIP: The installation will be much easier if you spread the pool and leave it in direct sunlight for app. 2 hours prior to installation. The material of the pool will be more flexible and you will be able to
spread it evenly during installation, avoiding any creases.
Recommendation: Place a suitable fabric liner beneath the pool bottom; it will protect the bottom from damage.
CIRCULAR POOL WITH FIXED FRAME
(c) Separate the supplied pools, T-couplings and other parts. The shorter pipes with larger diameter and a pair of holes on the ends are the horizontal girders (91). The longer pipes with smaller diameter
and a flexible lock (95) are the vertical braces (94). Take the horizontal girders (91) and slide them into the sleeves in the top part of the pool wall. Turn the girders so the holes at their ends are
aligned with the wall. Connect the girders around the entire circumference of the pool using the T-couplings (92) – the appropriate holes should be aligned. Do no secure the connection with pins
(93) yet. See figure 1 and 2.
(d) When you install the last T-coupling, install the pins (93) with sealing rings (97) in place – see figure 3.
Fig 1
(e) When the top frame is assembled and secured, put the vertical braces (94) in place. Flexible lock is pre-installed on one end of the vertical brace - this end should be oriented up into the T-coupling.
First, slide the vertical brace (94) between the pool wall and the belt in the middle of the wall (see fig. 4). Insert the top end of the brace into the appropriate T-coupling (92) and turn the brace to
secure its position using the flexible lock. Finally, place the foot (96) on the bottom end of the brace and press both parts together to the stop.
(f) Proceed along the entire circumference of the pool and install all vertical braces. Check, that the feet (96) are correctly fitted and the connections are secured using the T-couplings with flexible locks.
Then take the braces at their bottom ends and pull them gently outward from the centre into vertical position, to form a uniform circle.
T-coupling
Horizontal girder
Fig 2
Sealing ring
Pin
Fig 3
EN