Rectifying Faults; Guarantee - Waeco PerfectPower PP152 Notice D'emploi

_PP150_PP400_PP600.book Seite 26 Donnerstag, 12. November 2009 2:25 14

Rectifying faults

10 Rectifying faults
Fault
No output voltage
No output voltage
No output voltage
No output voltage
The device switches on and
off repeatedly
The inverter switches off
when the consumer is
switched on
The output voltage is too
low.
11

Guarantee

The statutory warranty period applies. If the product is defective, please
return it to the WAECO location in your country (see the back of the
instruction manual for the address) or to your dealer. For repair and
guarantee processing, please include the following documents when you
send in the device:
A copy of the receipt with purchasing date
Reason for the claim or a description of the fault
26
Cause
No contact to the battery
Overheating
Defective fuse (in the inverter
or the vehicle)
Device defective
Excessive constant load
Starting current too high
Batter voltage below 10.8 V
(PP152/PP402/PP602) or
21,5 V (PP154/PP404/PP604)
PerfectPower
Remedy
Check contact and cable.
Switch on the ignition if
necessary.
PP152/PP154: Check the
12/24 V socket and replace it
if necessary.
Switch off power consuming
devices.
Let the inverter cool down
and ensure better ventilation.
Replace the the fuse with one
of the same specifications.
Replace the device.
Reduce the load.
Compare the device power
with the maximum power of
the inverter.
Charge the battery (start the
engine).