Troubleshooting; Accessories; Before Returning For Repairs - Schumacher Electric DSR119 Manuel D'utilisation

9.

TROUBLESHOOTING

PROBLEM
The jump starter won't jump
start my car.
The jump starter won't power
my 12V device.
The battery in the jump
starter won't hold a charge.

10. ACCESSORIES

Male-to-male accessory cable ..................................................................................................94500109

11. BEFORE RETURNING FOR REPAIRS

For information about troubleshooting, contact customer service for assistance:
services@schumacherelectric.com | www.batterychargers.com | or call 1-800-621-5485
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP UNIT until
you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number from Customer Service
at Schumacher Electric Corporation.
POSSIBLE CAUSE
Clamps are not making a good
connection to the battery.
Connections are reversed.
The jump starter's battery is not
charged.
The vehicle's battery is defective.
The 12V device is not turned on.
The jump starter's battery is not
charged.
The 12V device draws more than
15A or has a short circuit.
The battery is bad (will not accept a
charge).
• 10 •
SOLUTION
Check for poor connection to battery
and frame. Make sure connection
points are clean.
Disconnect the jump starter and
reverse the clamps.
Press the Battery Status button on the
front of the unit. The LEDs will indicate
the status of charge.
Have the battery checked.
Turn on the 12V device.
Check the battery charge status by
pressing the Battery Status button.
Disconnect the 12V device. The
internal breaker will automatically
reset after a minute or two. Try the
12V device again.
Replace the battery.