Ayce YDZ-30D/S1 Manuel D'utilisation page 29

- LED display
In dehumidifying, it will indicate the actual room humidity. In timing mode, it
indicates the setting time.
- Fan speed button
In AUTO or CONTINUOUS mode, circularly selected the fan speed with High and and
low.
- Inside drying
Press this key for more than 2s to start drying procedure in the dehumidifier, this
can prevent mold inside the dehumidifier due to damp. The whole drying procedure
needs approximate 1h. Press this key again for more than 2s to cancel the drying
function in the dehumidifier, and to recover to running state before starting drying.
- Timer button – 24 hours timing
Press the key, to set the timing off or timing on, timing range is from 1 to 24 hours,
it will increase 1 hour by each press. Press twice continuously to cancel.
Timing off
When unit is working, press Timer button to turn off the unit according to your
setting time.
Timing on
When unit is standby(power on). press Timer button to turn on the unit according to
your setting time.
After setting, timer button flashes 5 times for confirmation.
- Air-swing function
Press the Timer button and the Drying button at the same time for more than 2
seconds to start or end the Air-swing function.
Other Instructions:
- Water tank full indicator light
Glows when the tank is ready to be emptied, or when the tank is removed or not
replaced in the proper position.
- Auto shut off
The Water Level Control Switch shuts off the dehumidifier when the water tank is
full, or when it is removed or not replaced in the proper position.
Auto Defrost
-
When frost builds up on the evaporator coils, the compressor will cycle off and the
fan will continue to run about 5-8 minutes to defrost.
Power Outage
-
In the case of a power outage or interruption, the unit will automatically restart, in
the settings last used, after the power is restored.
Drainage
Draining water can be storage in the water tank, or be continuous drained by PVC tube.
A) Drain the water manually
When the drainage tank is full, the tank full indicator light shown as red color and the
operation will stop automatically. The BUZZER sound 10times to remind the user till
water is drained. The water needs to be emptied from the drainage tank.
When water tank is full, water-full indicator is on, the unit will stop working, and buzzer
will sound 10times till water is pour off.
Emptying the drainage tank
1. Take out water tank and pour away water.
2. Once it is empty, replace the tank in the appliance. When replacing the drainage
tank, press the tank firmly into place with both hands. If the tank is not positioned
properly, the Water-full sensor will be activated, and the dehumidifier will not
operate.
B) Continuous external draining
If the appliance is to be operated for long periods but you are unable to empty the tank
regularly, you are recommended to use the continuous drain facility.
1. Find the position where the water outlet is blocked on the back, as shown in figure
below.
2. Pull down the water plug.
3. Connect the pvc drainage pipe(inner diameter of Ø9mm) onto the draining hole.
4. Make sure the water pipe is securely connected to the drainage outlet, otherwise
56 | 57 GB