Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product Descripation
2
9
10
11
1
Front panel
2
Louver
3
Control panel
4
side panel
5
Castor
6
Handle
Installation
- Location
Place the unit on a stable surface in the room and leave the
unit around at least 20cm and upwards at least 50cm so that
the air can circulate sufficiently.
- Electrical connection
Only connect this appliance to a adequately earthed socket.
Warning: Improper use of the grounded plug can result in
the risk of electrical shock.
6
3
7
1
4
8
12
5
7
Filter frame
8
Continuous drainage
9
Water tank
10
Handle of water tank
11
Cover of water tank
12
Power cable holder
Control Panel
Operation
-
Power button
Press this button to turn the dehumidifier on or off. First time to turn on, by default ,
the mode is dehumidifying automatically and low wind.
Mode button
-
When power or timing is on, press this button to choose auto dehumidifying or
continuous dehumidifying mode(dry cloth function). There is 2 second delay for
choosing any mode. And the indicator lamp corresponding to the selected mode is
on.
AUTO mode
Select AUTO dehumidification, if the room humidity is high than the set humidity or
is between +5% or -5% of the set humidity , the compressor will starts and the fan
will run at the set speed. If the room humidity is lower than the set humidity by -5%,
then the compressor will stop but the fan will run at the set speed. The default set
humidity value is 50%.
CONTINUOUS mode
Select CONTINUOUS dehumidification, no matter how the relative humidity in the
room is, the compressor starts, the fan runs at high speed in default, and the air
speed can be regulated via the air speed key.
Adjustable Humidity Button
-
The humidity level can be set within a range of 30% RH(Relative Humidity) to 80%
RH in 5% reduce or at continuous operation. The humidity setting is only valid in
AUTO mode.
54 | 55
GB
Publicité
Table des Matières
