Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
t (3b) for decreasing way. During the scanning you can change
the way by pressing the other key. The scanning stops as soon as
there is a busy channel. It automatically resumes 5 seconds later
if the channel becomes inactive.
Press any key (5, 6, 7 or 8) or the PTT switch (11) to deactivate the
SCAN. The dot disappears on the display.
4) ASC (Automatic Squelch Control) / SQUELCH
Suppresses undesirable background noises when there is no com-
munication. Squelch does not affect neither sound nor transmission
power, but allows a considerable improvement in listening comfort.
a) ASC: AUTOMATIC SQUELCH CONTROL
Worldwide patent, a PRESIDENT exclusivity
Turn the SQ knob (4) anti-clockwise into ASC position.
on the display. No repetitive manual adjustment and a permanent
improvement between the sensitivity and the listening comfort
when ASC is active. This function can be disconnected by turning
the switch clockwise. In this case the squelch adjustment becomes
manual again.
SC»
disappears from the display.
b) MANUAL SQUELCH
Turn the SQ knob (4) clockwise to the exact point where all back-
ground noises disappear. This adjustment should be done with
precision as, if set to maximum (fully clockwise), only the strongest
signals will be received.
5) F - MICROPHONE TYPE
See on page 10.
6) MODE ~ NB & COMPANDER
MODE
(short press)
This key allows you to select the modulation mode (AM or FM).
Your modulation mode has to correspond to the one of your
correspondent. Corresponding mode is displayed on the LCD.
Amplitude Modulation / AM: communication on a field with relief
-
and obstacles at middle distance (the most used).
-
Frequency Modulation / FM: for nearby communications on a flat
open field.
NB & COMPANDER
Long press the NB/
NOISE BLANKER : This filter allow the reduction of back ground
noise, and some reception interference. "NB" is displayed when
NB filter is active.
COMPANDER
«AS
appears
tion mode.
7) EMG ~ EMG STORE
EMG
(short press)
Emergency channels will be automatically selected by pressing
the EMG key (7). First press : emergency channel 1 is activated.
Second press: emergency channel 2 is activated. Third press: return
to the current channel. "EMG" appears on the display when an
emergency channel is activated. The default emergency channels
are channel 9/AM (1) and channel 19/AM (2).
Note: Activating an emergency channel prevents use the PA (see
§ PA page 11) mode. If the KEY BEEP function is activated, an
error beep sounds .
EMG STORE
Emergency channel can be stored to any channel with mode
AM or FM. To set a new emergency channel:
-
Short press on EMG key (7) to call the current emergency channel.
"EMG" appears on the display.
Long press on EMG/STORE key (7).
-
"EMG" blinks.
-
Using the s/t keys (3) on the unit or the UP/DN knobs (12) on the
microphone, select the new emergency channel.
8
(long press)
key (6)
to change the status of the filters :
: this switchable filter allow to improve the recep-
(long press)
appears on the display and
Publicité
Table des Matières
