Changing The Filter; When The Work Is Done - Bosch BSG L5 Série Mode D'emploi

GA 8001 006 657_BSGL5_GL50 17.10.2014 09:14 Seite 48
Special accessories
17
Figure
● Remove the crevice nozzle or upholstery nozzle from
the accessories compartment in the appliance lid.
18
Figure
Attach the nozzles to the suction pipe or handle as
required:
a)Crevice nozzle for vacuuming crevices and corners, etc.
b)Upholstery nozzle for vacuuming upholstered
furniture, curtains, etc.
19
Figure
● After use, place the crevice or upholstery nozzle back
into the accessories compartment in the appliance
lid.
20
Figure Hard-floor tool
For vacuuming hard floor coverings
(tiles, parquet flooring, etc.)
● Push the telescopic tube into the connecting piece
of the hard floor tool until it locks in place.
● To release the connection, press the locking collar
and pull out the telescopic tube.
21
Figure
● You can use the parking aid on the back of the
appliance if you wish to stop vacuuming for a short
time.
● Once you have switched off the appliance, slide the
hook on the floor tool into the recess on the rear of
the appliance.
22
Figure
To overcome obstacles, e.g. steps, the appliance can
also be carried by the handle on the appliance body.

When the work is done

23
Figure
● Pull out the mains plug.
● Tug the power cord briefly and then let go
(the power cord retracts automatically).
24
Figure
● To store or transport the appliance, you can use the
storage aid on the underside of the appliance.
● Stand the appliance up on its end. Slide the catch on
the floor tool into the groove on the underside of the
appliance.
48
Changing the filter
! Please note: Always switch off the appliance before
changing the filter.
Replacing the bag
25*
Figure
If the dust bag change indicator lights up red
continuously when the floor tool is lifted from the floor
and the highest power setting has been selected, the
dust bag must be changed, even though it may not yet
be full. Even if the dust bag is not full, it may still need
changing, due to the type of dust which has been
vacuumed.
First check that the nozzle, suction pipe and flexible
hose are not blocked, as this would also lead to the
dust bag change indicator being triggered.
26
Figure Opening the lid
● Open the lid by moving the locking lever in the
direction of the arrow.
27
Figure
a) Seal the dust bag by pulling the sealing plate, and
remove the bag.
b)Slide the new dust bag into the holder up to the stop.
! Please note: the lid will only close if a dust bag has
been inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by tapping out the dirt and rinsing.
28*
Figure
● Open the dust bag compartment lid.
● Remove the motor protection filter from
the appliance in the direction of the arrow.
● Disconnect the motor protection filter from the Bionic
filter.*
● Clean the motor protection filter by tapping out the
dirt.
● If it is very dirty, the motor protection filter should be
rinsed. The filter must then be left to dry for at least
24 hours.
Please note: the Bionic filter must not come into
!
contact with water, as this will adversely affect the
correct operation of the filter.
● After cleaning, place the Bionic filter onto the motor
protection filter as necessary and push both filters
into the appliance.
● Close the dust bag compartment lid.
* Dependent on model
Figure 26