Laminating; Removing A Jammed Laminating Pouch - Titanium HomeOffice PL 250 Guide D'utilisation

− Only use one laminating pouch per lamination, as
laminating pouches may stick tightly together.
− Do not leave any laminating pouches in or next to the
laminator after lamination.
When using the laminator, a slight odour may be produced.
Ensure there is sufficient ventilation in the room, e.g. by opening windows.

Laminating

1. Move the ON/OFF switch
The ready indicator will turn from dark blue to red within the next 1 ½–2 minutes.
2. Once the ready indicator
laminating pouch.
Make sure that the document is flush with and aligned as close as possible to the
sealed edge of the laminating pouch.
3. Insert the laminating pouch so that it is centred and with the closed-edge first into
the laminating pouch infeed slot
The heating rollers will automatically pull the laminating pouch in and move it to
the laminating pouch output slot
out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
• If necessary, you can cut off excessive material after it has cooled off.
• Repeat the process if the laminating pouch has not adequately
adhered to the document.
5. Move the ON/OFF switch

Removing a jammed laminating pouch

The laminator is equipped with an antiblocking system. If the laminating pouch was
not inserted straight or it becomes jammed in the laminator, proceed as follows:
1. Move the ABS switch
2. Pull the laminating pouch out of the laminator.
It is recommended you pull the laminating pouch out in the direction of its
larger end.
You can place the document in a new laminating pouch and laminate it again.
28
28
2
to "ON" (–).
1 is red, place the document between the two sides of the
3 on the back of the laminator.
4
on the front of the laminator. Don't use force to pull
2
to "OFF" ( O ) to switch the laminator off.
5 towards the laminating pouch infeed slot 3 and hold it down.