Wheel Adjustment; Abrasive Assembly Procedure - Bona Scorpion DCS Manuel D'utilisation

Machine Adjustment Procedures (Cont.)

Wheel adjustment

To adjust wheel position, proceed as follows:
1.
Open the belt safety guard by
loosening the screws.
4.
Turning the adjustment screw
counter-clockwise raises the
drum end on the motor fan
side from the floor.

Abrasive Assembly Procedure

Fit the abrasive disc to the drum ensuring that the abrasive protrudes approximately 1.5mm from
the drum itself.
Do not start the machine without the abrasive inserted, otherwise the drum will be damaged and must be
replaced.
The abrasive is in the correct position when it protrudes approximately 1.5mm from the sander drum.
Using a damaged abrasive may cause damage to the machine or floor. An abrasive which is not stretched
correctly or is damaged could tear while sanding and damage the machine or floor.
When replacing the abrasive belt always disconnect the power supply cable from the wall socket and not
the handle/motor interconnection cable.
Failure to heed this advice could result in the machine and drum starting up, risking injury to the hands.
18
5.
Once the desired position
has been reached secure the
locking nut.
2.
Loosen the locking nut.
Bona Scorpion DCS Manual
3.
Turning the adjustment
screw clockwise lowers the
drum end on the motor fan
side towards the floor.