Stadler Form Scale One Mode D'emploi page 9

4. At this point, press the keys
keys pressed, the scrolling of the numbers becomes faster. Press the
MODE key to confirm the set time of the alarm clock. After few seconds,
the display shows the previously set time (fig. 2).
5. To enable the alarm clock function, press the key
shows the icon . To disable the alarm clock function, press the key
again; the icon disappears from the display
If during the alarm clock time setting no key is pressed within 1 minute, the
numbers on the display stop blinking and the display shows the previously
set time (fig. 2).
Then, repeat the procedure from point 1.
When the alarm clock set time is reached, the scale emits a long acoustic
signal. Press any key to stop it.
Moreover, it is possible to enable the "Snooze" function: When the set
time for the alarm clock is reached, stop the acoustic signal by pressing the
"SNZ" key positioned on the bottom of the scale. After 8 minutes, the scale
emits the acoustic signal again. Press any key among the ones positioned on
the bottom of the sale to stop it or press the key "SNZ" once again to delay
the alarm clock by further 8 minutes. During the SNOOZE function, the icon
and the colon between hours and minutes blink on the display.
Caution! The set alarm clock time remains stored. The display shows the
bell icon on the left side of the display near to the time indication. To
disable the alarm clock function, press the key
from the display. By pressing the key
is enabled again for the time already set.
OVERLOAD
The message "Err", "EEEE" or "0-Ld" indicate an overload.
CLEANING
• Attention: Never immerse the appliance in water.
• To clean the appliance, only wipe it down with a damp cloth and then dry
it carefully.
SPECIFICATIONS
3 x 1,5 volt AAA alkaline batteries
2 LCD displays
Maximum tolerance: +/-1%
Room temperature measurement range:
+10 °C and +40 °C (+40 °F and +104 °F)
Thermometer resolution: 0.1 °C
Room humidity measurement range: 20% and 90%
Storage environmental requirements: +10°C ÷ +50°C; RH 90%
Operating environmental requirements: +10°C ÷ +40°C; RH 90%
All rights for any technical modifications are reserved
The conformity, certified by the CE-marking on the device, refers to the EEC
Directive 2004/108 on electromagnetic compatibility.
and to set the minutes. Keeping the
once; the display
.
; the icon disappears
once again, the alarm clock function
REPAIRS/DISPOSAL
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the guarantee
lapses and all liability is refused.
• Never operate the appliance after it has malfunctioned, if it has been
dropped or has been damaged in any other way (cracks/breaks in the cas-
ing).
• Do not push any object into the appliance, do not disassemble the ap-
pliance.
• If the appliance is beyond repair, make it unusable immediately and hand
it in at the collection point provided for the purpose.
• Do not dispose of electrical appliances in the domestic waste. Please use
the communal collection points.
• Ask your local authority if you do not know where the communal collec-
tion points are located.
• If electrical appliances are disposed of thoughtlessly, exposure to the ele-
ments may cause hazardous substances to find their way into the ground-
water and from there into the food chain, or to poison the flora and fauna
for many years to come.
• If you are replacing the appliance with a new one, the seller is legally
obliged to take back the old one at least free of charge for disposal.