Zeiss M LED Mode D'emploi page 6

ZEISS MOUNTING THE TRANSMITTED LIGHT ILLUMINATORS M LED
Fig. 3 Mounting the Transillumination Unit
4
3.2 Mounting the Transillumination
Unit M LED
•
Unplug the power supply cable from the
stand.
•
Place the Transillumination Unit on a stable
surface.
•
Unscrew the 3 mm Allen screw (Fig. 3/1) on
the front of the stand and place it to one side.
•
Screw the
(Fig. 3/2) in completely.
•
Remove the cover flap (Fig. 3/3).
•
Carefully
Transillumination Unit from the rear. Push it
forwards until the stand plate and transmitted
light housing are flush. The two lugs (Fig. 3/5)
must slot into the recesses (Fig. 3/4).
•
Screw the 3 mm Allen screw into the tapped
hole (Fig. 3/6) of the Transillumination Unit
and tighten by hand.
•
Return the stand to upright and, if necessary,
prevent wobbling by adjusting the height-
adjustable foot of the Transillumination Unit
(Fig. 3/7).
•
Plug the power supply cable back into the
stand.
To disassemble the Transillumination
Unit M LED, unscrew the Allen screw,
carefully push the stand backwards
and remove it.
435425-7144-008
Stand M LED
height-adjustable stand
mount the stand onto
foot
the
06/2016