Zeiss M LED Mode D'emploi page 5

Stand M LED MOUNTING THE TRANSMITTED LIGHT ILLUMINATORS M LED
3 MOUNTING THE TRANSMITTED
LIGHT ILLUMINATORS M LED
CAUTION
Switch off the stand and unplug the
power supply cable from the stand
before mounting the transmitted light
illuminator.
3.1 Mounting the Transilluminator
Brightfield M LED
•
Unplug the power supply cable from the
stand.
•
Gently tilt the stand backwards and put it
down.
•
Unscrew 3 mm Allen screw (Fig. 2/1) and put
it to one side.
•
Remove cover flaps (Fig. 2/2 and 3).
•
Insert the Transilluminator Brightfield so that
the two pins (Fig. 2/4) click into the recesses
(Fig. 2/5) on the bottom of the stand.
•
Press the Transilluminator Brightfield against
the stand base and hold tight.
•
Screw the 3 mm Allen screw into the tapped
hole (Fig. 2/6) of the stand until the tip of the
screw engages in
Transilluminator Brightfield.
•
Tighten the Allen screw hand-tight.
•
Return the stand to upright and, if necessary,
prevent wobbling by adjusting the height-
adjustable foot of the stand base (Fig. 2/7).
•
Plug the power supply cable back into the
stand.
06/2016
the hole of the
435425-7144-008
Fig. 2 Mounting the Transilluminator
Brightfield M LED
ZEISS
3