Beko DC 7230 Mode D'emploi page 35

will stop during the following drying cycles
when the water tank is full and the "Water
tank" warning light will turn on. If this is the
case, press the "Start/Pause/Cancel" button
to resume the drying cycle after draining the
water tank.
To drain the water tank:
1-Carefully remove the water tank by opening
the kick plate cover/pulling the drawer.
2-Drain the water in the tank
3-If there is lint accumulation in the funnel of
the water tank, clean it under running water.
4-Place the water tank into its seat.
For the condenser;
Hot and humid air in the condenser is cooled
with the cold air from the room. Thus,
the humid air circulating in your dryer is
condensed and then pumped into the tank.
C
Clean the condenser after every 30 drying
cycles or once a month.
To clean the condenser:
1. If a drying process has been carried out,
open the door of the machine and wait
until it cools down.
2. Unlock the 2 condenser locks after opening
the kick plate.
3. Pull out the condenser.
4. Clean the condenser by applying
pressurized water with a shower armature
and wait until the water drains.
5. Place the condenser in its housing. Fasten
the 2 locks and make sure that they are
seated securely.
6. Close the kick plate cover.
35 EN