Publicité
A
Function
Pump basket (front section)
by streamON 1800 and axle with sleeve by streamON 3000 and 3800
Pump with pump basket
B
Assembly
Using a rotating motion, insert one comfort-silence suction cup into
each of the two lower and upper openings of the pump holder plate
(Fig. B
). Now mount the holding plate inside the aquarium at the
1
desired position (Fig. B
Click the EHEIM flow pump into the pump holder below the water
(Fig. B
).
3
C
Putting into operation
Place the streaming pump into the aquarium in such a way that it will
not cause any damage if it accidentally falls off. So that the pump does
not draw-in any air, it should be mounted approximately 10 cm below
the surface of the water. Set the desired direction of flow by rotating
sideways to the left or right when holding plate is positioned vertically
(Fig. C
and C
1
pump holder is positioned horizontally (Fig. C
Switch on using the mains plug.
D
Care and Cleaning
Unplug the mains plug and make sure that the pump is de-energized.
To remove the pump, gently press the tab on the pump holder away
from the pump and remove the pump by tilting it backwards out of
the holder (Fig. D
dirt from the pump basket. Remove any blockages from the flow
opening if they are clogged.
).
2
) or by inclining the pump backwards or forwards if the
3
). Use a brush or a sponge to clean away coarse
1
Pump wheel
Pump holder
full-floating axles
4 suction cups
and C
).
3
4
Publicité
