Control Panel - Evolite ArchiTECH 600 Mode D'emploi

 Set up

Control panel

o
The control board offer several features: you can simple set the starting address, run the pre-
programmed program or make a reset.
 POWER IN/POWER OUT：Power input / output
 DMX IN/DMX OUT：DMX signal input and output interface.
 ：Menu button/return button,enter the menu selection interface or previous menu.
 ：Confirmation button, used to confirm the selected function.
 ：Upward/downward select function or Parameter increment / decrement.
NO. Main menu
MENU
1
2 ADDR
DISP
3
4 Dimmer
5 Mode
ArchiTECH 600 Manual Ver. 1.00
Primary-menu Sub-menu
Linear
Exponential
Dimmer Curve
Logarithmic
S-Curve
Quiet
Studio
FAN Live
AUTO
Factory Set Password
001~512
0~8
DMX-512
RED
GREEN
Static BLUE
WHITE
Strobe
Note
Light intensity increases linearly with DMX
value
Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher
DMX values.
Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values.
Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted
at medium DMX values.
Fan off, total power output reduced by 20%.
Low speed, light output 100 %
High speed, light output 100 %
Temperature control mode, reach 40 °C begin
to work
Password is：
UP+UP+DOWN+DOWN+ENTER
DMX address settings
Display orientation settings
Fine dimming settings
DMX-512 console mode
000~255
000~255
000~255
000~255
000~255
Static color settings
17
Page