Avanti WDBMC800Q3S Manuel D'instructions page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DO NOT TURN ON THE HOT WATER POWER SWITCH BEFORE FILLING THE HOT WATER
TANK WITH WATER. THIS WILL CAUSE THE UNIT TO OVERHEAT AND SHUTDOWN.
Install the water bottle and allow the tanks to fill with water for approximately 10 – 15 minutes.
Before turning on the HOT water power switch.
Your unit is equipped with an AUTOMATIC SAFETY SHUTOFF SWITCH which will turn the unit
off until the hot water tank cools to a safe temperature.
Usual time to reset is approximately 30 – 45 minutes, once the temperature reaches a safe level,
the unit will reset and begin to operate normally.
If the unit has gone into RESET MODE, turn off the hot water power switch ensure there is water
in the tanks and allow the unit to cool down.
BEFORE PLUGGING IN YOUR UNIT
1) Make sure the water dispenser is not plugged into an electrical outlet.
2) Open the door of the lower cabinet.
3) Place a full bottle of water on the floor.
4) Remove the plastic cover from the mouth of the water bottle.
5) Insert the water supply hose and secure the bottle cap to the mouth of
the water bottle.
6) Slide the bottle into the lower cabinet and close the lower cabinet
door.
7) Plug the water cooler into an electric outlet as indicated previously in
this manual.
8) The motor will begin to pump water up to the water tanks.
9) After the pump stops working (wait approximately 10 minutes), then
dispense water from both the hot and cold faucets.
10) After dispensing water from the faucets for the first time, then turn on
the power to the HOT and COLD power switches at the rear of the unit
to begin the heating and cooling process.
11) If you are not going to be using the HOT function, turn the HOT power
switch off to conserve energy.
REPLACING AN EMPTY BOTTLE
When the unit is out of water or needs a bottle change the
power indicator light will blink on and off to indicate that a new
water bottle is needed.
You may hear a sucking noise when the bottle is empty and
needs to be changed. This is normal and is another way to know when the bottle is
empty and needs to be changed. Replace the bottle as soon as you notice it is
empty.
Your water dispenser features an adjustable quick connect system. For proper
operation, make sure the connector is sealed tight (fig 1)
The connector can be removed easily for cleaning with warm soapy water (fig 2)
The tube can be adjusted up and down to accommodate both 3 and 5 gallon water
bottles (fig 3).
NOTE: If there is not a secure connection between the hose cap and the connector
on the water cooler the water pump will operate but will not dispense water. Make
sure the hose is connected to the water dispenser correctly.
ATTENTION / WARNING
8

Publicité

Table des Matières
loading

Table des Matières