Introduction; How Does The Air System Function; Functions Of Isensi System; Control Panel - HOESCH iSensi Instructions De Montage Et D'utilisation

07

Introduction

07.01 How does the Air system function?

The air sucked by the blower is carried by air pipes located under the bottom of the bathtub and via bottom nozzles to the
inside of the bathtub full of water.
08

Functions of iSensi system

08.01 Control panel

1 Switch off everything
switching all functions off.
2 air pump on/off.
Short pressing of button 2 turns the pump on with 100% power.
Pressing this button during operation turns the pump off.
3 air pump power control button and wave effect button
from air jets. Active when air pump is on. Short pressing of
button 3 changes the air pump performance. The adjustment is
as follows: at further pressing the button reduced the revolution
speed to the minimum value. After the pump has reached the
minimum speed, and button 3 is still pressed, the speed of the
pump is increased to the maximum value. The pump speed
control range: 30 – 100%. Holding button 3 for 5 sec. switches
on wave effect from the air jets. By Pressing button 3 while the
wave effect is active, the wave effect switches off and speed
stabilizes at the current level.
4 lighting on/off
5 This functions are not activ in this product version
6 This functions are not activ in this product version
7 8 9
1 2 3
10 11 12
4 5 6
7 red LED indicates power supply and operation
readiness of the unit,
continuous lighting – controller in on, required water
level is reached
no lighting – no power supply of the controller,
"slow" blinking light (1 second) – "STANDBY" mode
– power supplied to the controller, no operation,
(time measurement to drying cycle)
8 red LED indicates blower operation.
continuous light – air pump on,
(time measurement to drying cycle),
no lighting - air pump off
9 red LED indicates blower speed change,
continuous light – wave effect active from air jets
(continuous change of speed).
no lighting – wave effect not active
10 red LED indicates light operation.
11 This functions are not activ in this product version
12 This functions are not activ in this product version
GB
17