SOLAC espression CA 4805 Mode D'emploi page 58

PROBLEM
- No steam or hot water is obtained.
- The coffee-maker needs a lot of time to
make the coffee.
- The brewing unit does not fit in place
after it has been removed for cleaning.
No coffee comes out of the outlets
.
CAUSE
* You have not pressed the button and
the coffee bean container is empty.
* You have poured ground coffee in the
dispenser when the coffee machine was
turned off.
* Part of the ground coffee is still in the
inlet funnel.
The steam nozzle is blocked.
The grind is too fine.
The piston that presses down the coffee
has moved.
The coffee outlet is blocked with dry cof-
fee remains.
The pipes through which the coffee
comes out of the coffee-maker into the
outlet are blocked.
28
SOLUTION
Press the button again.
Clean the ground coffee dispenser. Re-
peat the operation by pressing the button
again.
Remove the coffee remains with the
brush included in the accessories, or with
the back of the dosage spoon.
Clean the blocked pipe with a needle.
IMPORTANT! During this operation, the
steam regulator must be closed and the
coffee-maker turned off.
Select a coarser grind.
Use the brewing unit spanner to position
the piston in place (as indicated in section
16. CLEANING AND MAINTENANCE, sec-
tion B) BREWING UNIT).
Remove the coffee outlet and wash it un-
der the tap.
Remove the coffee outlet. Clean the
blocked pipe(s) with a needle
IMPORTANT! During this operation,
the coffee-maker must be turned off.