Getting Started - Kenwood KMM-100 Mode D'emploi

GETTING STARTED

1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display shows:
"CANCEL DEMO" \ "PRESS" \ "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [SETTINGS], then press the knob.
3
Turn the volume knob to select [CLOCK], then press the knob.
4
Turn the volume knob to select [CLOCK ADJ], then press the knob.
5
Turn the volume knob to adjust the hour, then press the knob.
6
Turn the volume knob to adjust the minute, then press the knob.
Press 4 / ¢ to move between the hour and minute adjustment.
7
Press and hold
(or)
Press and hold SCRL DISP to enter clock adjustment mode directly while in clock
display screen.
Then, perform steps
3
Set the initial settings
1
Press SRC to enter [STANDBY].
2
Press the volume knob to enter [FUNCTION].
3
Turn the volume knob to select [INITIAL SET], then press the knob.
4
Turn the volume knob to make a selection (see the following table), then press the
knob.
5
Press and hold
• To return to the previous hierarchy, press
4
to exit.
5 6
and above to set the clock.
to exit.
.