Velleman VCC2 Mode D'emploi page 9

2) Scheduled Recording
- A programmable timer is used for scheduled recording.
- The DSR supports both weekday and weekend scheduled recording.
- The timer will start and stop scheduled recording according to your input.
- A green indicator shows that the camera is recording under timer control.
- The default recording duration is 0, which represents infinity or continuous recording.
- During scheduled recording, you can manually override and start the instant recording mode by
pressing the camera button on the 'RECORDER PANEL' and the light will turn yellow to indicate that
the camera is in instant recording mode.
- However, it will automatically resume scheduled recording once you click the camera button to turn
off that camera. The indicator will turn green again.
- Please see 'Scheduled Recording Setting' for the setup and an example of scheduled recording.
Note: Only by using the logon username 'SUPER' can you gain access to the configuration settings for
scheduled recording.
Note: The instant recording video will be chopped into files of 15 minutes in order to keep the files at an
accessible size.
3) Alarm Recording
- Alarm Recording will be triggered by motion detection.
- Once the alarm is triggered by the motion detection, the corresponding camera will start recording
automatically.
- A red light indicates that the camera is now in alarm recording mode.
- The alarm recording function of an individual camera can be disabled. The alarm recording duration
and the frame rate of each camera can be programmed individually.
- Please see 'Alarm Recording Setting' for setup details.
Note: Only by using the logon username 'SUPER', can you gain access to the configuration settings for
scheduled recording.
4) Pre-Alarm Recording
- Pre-alarm recording works together with alarm recording, which enables you to capture images
before the alarm event has happened.
- Pre-alarm allows images to be temporarily recorded for a short period of time (1 to 60 seconds) in
normal conditions. Once an alarm has been triggered, the pre-alarm images become permanent
files which can be retrieved and played back with the 'Play Back' function.
- The pre-alarm function is set in 'Alarm', 'Recorder Setting' in the 'Utility' menu.
- You can activate the pre-alarm function if the alarm function is selected.
- Please see 'Alarm Recording Setting' for setup details.
5) Scheduled Alarm and Motion Detection
A programmable timer is implemented for scheduled alarm and motion detection.
Please see 'Alarm Recording Setting' for setup details.
VCC2
9
VELLEMAN