RedMax HB281 Manuel D'utilisation page 9

• Examine the stop switch for correct operation.
• Examine the product for fuel leaks.
To start a cold engine
WARNING:
rope around your arm.
CAUTION:
with your foot.
CAUTION:
rope to the end position. Do not let go of
the starter rope handle when the starter
rope is extended. This can damage the
product.
Note:
If the engine stops, move the choke control
to the closed position and do the starting steps
again.
1. Fill the fuel tank with a clean fuel mixture.
2. Push the primer bulb 10 times.
3. Move the engine choke control to the FULL
CHOKE (closed) position.
240 - 004 - 13.01.2022
Do not wind the starter
Do not hold the product
Do not pull the starter
4. Push the variable speed control fully
counterclockwise.
5. Use your left hand to hold the body of the
machine on the ground.
6. Pull the starter rope handle until the engine tries
to run. Do not pull more than 3 times.
7. Move the choke control to the 1/2 position and
pull the starter rope handle until the engine starts
and runs.
8. Run the engine for approximately 10 seconds.
9. Push and hold the throttle trigger fully through all
remaining steps.
10. Move the choke control to the OFF CHOKE
(opened) position.
11. Warm the engine up for 1 minute.
To start a warm engine
1. Push and hold the throttle trigger.
2. Move the choke control to 1/2 position.
3. Pull the starter rope handle quickly while you pull
the throttle trigger until the engine runs.
9