Basic Settings - Carson Dragster 6S Mode D'emploi

If you intend to connect
2 battery packs in series, please
use this schema:
Red power wire
(battery positive)
ESC (+) red
d. Basic Settings
Throttle range setting
(throttle range calibration)
In order to make the ESC fit the throttle range
of your transmitter, you must calibrate it for the
following cases; otherwise the ESC cannot work
properly.
There need to be set 3 points. They are the end
point of "forward", the end point of "backward" and
the neutral point.
The following pictures show how to set the throttle
range with your transmitter.
Black power wire
(battery
negative)
ESC
black
ESC (-)
black
CARSON Brushless Speed Controller Dragster 6S
ESC red
Red power wire
(battery positive)
2 batteries connected in series
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the
throttle lever, the ATV or EPA parameters, etc.
A) Switch off the ESC and turn on the
transmitter.
B) Hold the "SETUP"-key of the ESC and then
switch on the ESC. Release the "SETUP" key
as soon as the red LED begins to flash.
Black power wire
(battery negative)
21
GB