Technical Data - elem Garden Technic CBE18VLI Instructions D'origine

Cutting the grass in a tight place or
on a slope
WARNING:
• When cutting the grass on a slope, be careful of
stones, grass and other foreign objects thrown from
the cutting head area.
• When cutting the grass on a slope, make sure
that you always keep a good and stable footing.
To ease the work in a tight place which restricts the
height, such as cutting the grass under an outdoor
wood deck and similars, push the lock button and
then bend down the cutting head so that the shaft is
parallel to the ground surface. Adjusting the cutting
head angle properly in this way helps you cut the
grass on a slope.
MAINTENANCE
WARNING:
• Always be sure that the tool is switched off and
battery cartridge is removed before attempting to
perform inspection or maintenance on the tool.
Failure to switch off and remove the battery
cartridge may result in serious personal injury from
accidental start-up.
NOTICE:
Clean the exterior of the machine thoroughly us-
ing a soft brush and cloth. Do not use water, sol-
vents or polishes. Remove all grass and debris,
especially from the ventilation slots.
Turn the machine on its side and clean the cut-
ting guard inside. If grass cuttings are com-
pacted, remove with a wooden or plastic imple-
ment.
Check if guards and protective devices are un-
damaged and properly mounted. Before using,
carry out possibly necessary maintenance and
repairs.
The battery should be stored between 0 ° C and
45 ° C.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment
should be performed by ELEM GARDEN TECHNIC
Authorized Service Centers, always using ELEM
GARDEN TECHNIC replacement parts.

TECHNICAL DATA

No load speed min-1
Max. cutting circle mm
thread
Systeme
Weight kg
Battery LITHIUM ref « BAT18VLI »
Voltage
Capacity
autonomy
Charger for « BAT18VLI »
Mains voltage V
Mains frequency Hz
Charging time
Class of protection
Values of noise emissions measured by the
standard:
Acoustic pressure level LpA
75 dB(A) K = 3 dB(A)
Acoustic power level LwA
90.8 dB(A) K = 3 dB(A)
Guaranteed sound power
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. :
Main handle 6.531 m / s ²
Auxiliary handle 6.764 m / s ²
K= 1.5 m/²
8000
250
1.2mm
Tap&Go
2.0~3.0
18V
1.3Ah
25min
230
50
3~5h
LwA 96 dB(A)
ATTENTION !
must be worn.
28