Troubleshooting - SilverCrest SPBS 5000 A1 Mode D'emploi

Troubleshooting

A connected device is not charging.
♦ Press the ON/OFF button
♦ The solar charger's battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ The solar charger can be used for end devices that require a
charging current of no more than 2,1 A. If the connected end
device requires a current of more than 2,1 A, the solar charger
will switch itself off immediately after being switched on with
the ON/OFF button
ability for your end device on the basis of the technical data
of your end device.
The device will not switch on.
♦ The device has switched itself off automatically. You need to
charge the device for a short while with a USB mains adapter
before you can switch the device back on.
The solar charger's battery is not charging via the solar
panel.
♦ Check that the solar panel
NOTE
► If the above-mentioned solutions do not resolve the problem,
please contact Customer Service (see chapter Service).
SPBS 5000 A1
briefly to start the charging process.
. In this case, check the charger's suit-
is receiving sufficient sunlight.
GB │ IE │ NI │
15 ■