Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rear Panel
1
1.
Power Input: Connect the included power cable here.
2.
Power Amplifier Output: This sends the main/master signal to your amplifier.
Connect this to your amplifier using a properly wired 4-pin Euroblock connector
and speaker wire. See the section
information.
Note: This output is always summed to a mono signal.
3.
Master Output: Connect this balanced mono XLR output to a powered
speaker.
Note: This output is always summed to a mono signal.
4.
USB LED: This LED will illuminate when the USB port is connected to a
computer's USB port.
5.
USB Port: Use the included USB cable to connect to a computer's USB port
for audio playback and recording.
Note: This output is always summed to a mono signal.
6.
1/8" (3.5 mm) TRS Input: Connect a line-level device such as a smartphone,
tablet, CD player, etc. here.
Note: Connecting to this jack disconnects USB input (playback). USB output
(recording) is unaffected. This allows for recording of three Bluetooth signals
and the 1/8" (3.5 mm) TRS input to the computer using the USB port.
7.
Bluetooth Antenna: Connect the 3 included Bluetooth antennas here for
pairing to Bluetooth sources.
5
2
3 4
6
Operation > Euroblock Setup
7
for more
9
Publicité
Table des Matières
