What To Do If - FUST NOVAMATIC ÖKO 2100-IB Notice D'utilisation

36
4. Defrost and clean the appliance and all
accessories.
5. Leave the lid open to prevent unpleas-
ant smells.

WHAT TO DO IF...

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Problem
The appliance is noisy
The compressor oper-
ates continually
There is too much frost
and ice
The lid doesn't close
completely
The lid is difficult to open
It is too warm in the
freezer
Possible cause
The appliance is not supported
properly
The temperature is not set cor-
rectly.
The lid has been opened too fre-
quently
The lid is not closed properly
Large quantities of food to be
frozen were put in at the same
time
Food placed in the appliance
was too warm
The temperature of the room
that contains the appliance is
too high for efficient operation
Products are not wrapped prop-
erly
The lid is not shut properly or do
not close tightly
The temperature is not set cor-
rectly.
There is excessive frost
The lid gaskets are dirty or sticky
Food packages are blocking the
lid
The lid gaskets are dirty or sticky
The valve is blocked
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly
Important! If the cabinet will be kept on,
ask somebody to check it once in a while to
prevent the food inside from spoiling in
case of a power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
Set a warmer temperature
Do not leave the lid open longer
than necessary
Check if the lid closes well and
the gaskets are undamaged and
clean
Wait some hours and then check
the temperature again
Allow food to cool to room tem-
perature before storing
Try to reduce the temperature in
the room where the appliance
stands
Wrap the products better
Check if the lid closes well and
the gaskets are undamaged and
clean
Set a warmer temperature
Eliminate excess frost
Clean the lid gaskets
Arrange the packages in the right
way, see the sticker in the appli-
ance
Clean the lid gaskets
Check the valve
Set a lower temperature
Check if the lid closes well and
the gasket is undamaged and
clean
Solution