Relay-Operation; Faderstart; Effects; Scratch-Function - Omnitronic CDP-600 Mode D'emploi

The player repeats the sequence between A-point and B-point until you press the Exit-button.

6.9 Relay-operation

In the Relay-operation, the device automatically switches to the other player after playback has stopped. In
this way, you have the possibility to enlarge the music program by using several CDs. In the Single-mode,
on track is played and then the CD is changed, in Continuous-mode, CD1 is completeley played and then
CD2.
Press the Relay-button (LED on).
Start playback of CD1. As soon as the current track of CD1 is finished, the player automatically starts CD2.
The first CD-player goes into Pause-mode. You can enter a new CD or memorize a Cue-point at the
respective player in the Pause-Mode.
During the Relay-operation, the Faderstart-function is disabled.
You can switch the Relay-operation off via the Relay-button (LED off) and the Faderstart-function will work
again.

6.10 Faderstart

With the CDP-600, you have the possibility to start the respective CD-player direcatly from the mixer. Make
sure that the Start/Pause-socket is connected with the respective socket on the mixer. Additionally, the
Audio Out-sockets have to be connected with the Line-input sockets of your mixer. Please note that the
Faderstart-function only works with the appropriate mixers. Insert the CD and select the desired track
(Pause-mode). Start playback from your mixer.
Via the Remote Select-selector, you can choose between Tact and Lock.
Cue/Play
Please note that this selection is a Cue-point Faderstart-function. This means that the CD-player starts
playback after activating the respective channel of the mixer and goes into Pause-mode and returns to the
Cue-point after activating the channel again.
Prerequisites for the Faderstart-operation:
The mixer has to be connected via a 3.5 mm mono jack with the CD-player. For starting the playback, the
jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the playback,
the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.

6.11 Effects

The different effects can be activated via the On/Off-button. If the effect is selected via the Select-button, the
respective LED is permanently lit.
The effect-parameters can be adjusted via the Scratch-wheel.

Scratch-function:

The scratch-function resembles the scratching with a turntable. By turning the Scratch-wheel forwards and
backwards, different scratching-effects can be produced. If you turn the Scratch-wheel continuously
forwards, the playback resembles the playback-speed via the Play/Pause-button.
Flanger-effect:
When choosing the Flanger-effect, the effect of a jet engine is added to the original sound.
Filter-effect:
When choosing the Filter-effect, the original sound is modified in accordance with the parameter setting.
Reverse-function:
The unlimited reverse play can be activated via the Reverse-function. The playback-direction can be
changed as often as you like by pressing the On/Off-button.
28/55
10602320_V_1_0.DOC