Maintenance; Replacement Of Control Unit Fuse; Faults And Fault Detection; Discarding Instructions - Nouvag TCM Endo V Mode D'emploi

TCM Endo V

10.1 Replacement of control unit fuse

Defective control unit fuses can be replaced by the user without outside help. They can be found at the
back of the device in the fuse compartment next to the main switch:
1) Pull out mains plug
2) Open fuse compartment with a screwdriver.
3) Replace defective fuse T 1A.
4) Insert fuse holder again and close fuse compartment.
5) Check displayed mains voltage on fuse compartment.
6) Plug in mains plug again.
When setting the fuse compartment, please mind that the displayed voltage agrees
with the local mains voltage!
Fault:
Device does not run:
Footpedal does not
function:
End motor does not run:
File is not rotating:
"LED long bar" not
illuminated:
No acoustic signal:
If a fault cannot be eliminated, please contact the supplier or an authorised service agent. Relevant addresses
can be found on the last page of the operating instructions.
When discarding the device, device components and accessories, please comply with the issued
statutory regulations.
With regard to the preservation of the environment old equipment may be returned to the distributor or
manufacturer.
12

10 Maintenance

11 Faults and fault detection

Cause:
Mains connector not plugged
Wrong operating voltage
Defective device fuse
Footpedal not connected properly
Control unit not switched on
No motor connection
Motor not installed properly
Do not switch motor
File is not well inserted into contra
angle
Contra angle not correctly coupled to
motor
No contact between contact bow and
file
Contact pin on motor broken off.
No contact between contact bow and
file
Contact pin on motor broken off.

12 Discarding instructions

NOUVAG AG
Elimination:
Plug in mains plug
Check mains voltage
→See marking on fuse casing!
Replace defective fuse
Correctly insert footpedal cable at the back
of the control unit on footpedal jack
Switch on control unit with main switch at
the back
Connect motor cable to control unit
Press micro-motor firmly at the handle until
it locks into place
Switch on "Motor" button or footpedal
Insert file with slight pressure and rotation
into contra angle until file locks into place
and check fit with a slight pull in the
opposite direction
Couple contra angle to motor until it snaps
into place and check fit with a slight pull in
the opposite direction
Clamp contact bow on file firmly
Send device for repair (incl. motor and
contra angle)
Clamp contact bow on file firmly
Send device for repair (incl. motor and
contra angle)
No. 31943 35/05