Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Fig. H
Shoe Adjustment for 90°Cuts (Fig. H, I)
If Additional Adjustment is Needed
1. Adjust the saw to 0° bevel.
2. Retract the lower blade guard. Place the saw on
blade side.
3. Loosen bevel adjustment lever (
a square against the blade and shoe to adjust the
90° setting.
4. Turn the calibration screw (
will stop at the proper angle.
5. Confirm the accuracy of the setting by checking the
squareness of an actual cut on a scrap piece of material.
Fig. I
Kerf Indicator (Fig. J)
The front of the saw shoe has a kerf indicator
and bevel cutting. This indicator enables you to guide the
saw along cutting lines penciled on the material being cut.
The kerf indicator lines up with the left (inner) side of the
saw blade, which makes the slot or "kerf" cut by the moving
blade fall to the right of the indicator. Guide along the
penciled cutting line so that the kerf falls into the waste or
surplus material.
Fig. J
8
6
6
, Fig. H). Place
, Fig. I) so that the shoe
19
19
22
for vertical
22
Cut Length Indicator (Fig. K)
The markings on the side of the foot plate show the length
of the slot being cut into the material at the full depth of the
cut. The markings are in increments of 1/8" (3.2 mm).
Fig. K
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. L)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the auxiliary
handle
5
and one hand on the main handle
Fig. L
2
Trigger Switch (Fig. A)
WARNING: This tool has no provision to lock the
trigger switch in the ON position and should never be
locked ON by any other means.
Pull the trigger switch
1
the trigger turns the motor off. This tool has no provision to
lock the switch in the on position, and the tool should never
be locked on in any way.
Workpiece Support (Fig. L–N)
WARNING: It is important to support the work
properly and to hold the saw firmly to prevent loss of
2
.
to turn the motor on. Releasing
5
Publicité
Table des Matières
