Running The Dell Ide Hard Drive Diagnostics - Dell OptiPlex DHS Guide De Configuration Et De Référence Rapide

NOTE: This feature
changes the boot sequence
for one time only. On the
next start-up, the
computer boots according
to the devices specified in
system setup.
10
Setup and Quick Re ference Guide
NOTICE: If your hard drive fails, run the Dell IDE Hard Drive Diagnostics
(see "Running the Dell IDE Hard Drive Diagnostics" on page 10).
Turn on your computer (if your computer is already on, restart it).
1
F2 = Setup
When
2
press <Ctrl><Alt><F10>.
The diagnostics initialization begins immediately; then the
Diagnostics Menu appears.
Select the appropriate diagnostic option for your computer.
3
To use the diagnostics, follow instructions on the screen.
Changing the Boot Sequence
To run the Dell Diagnostics from the Drivers and Utilities CD, perform the
following steps to enable your computer to boot from the CD:
Insert the Drivers and Utilities CD into the CD drive.
1
Turn on (or restart) your computer.
2
F2 = Setup
When
3
press <Ctrl><Alt><F8>.
The Boot Device Menu appears.
If you wait too long and the Windows logo appears, continue to wait
until you see the Windows desktop. Then shut down your computer
and try again.
Select the CD-ROM Device option.
4

Running the Dell IDE Hard Drive Diagnostics

The Dell IDE Hard Drive Diagnostics is a utility that tests the hard drive to
troubleshoot or confirm a hard drive failure.
Turn on your computer (if your computer is already on, restart it).
1
F2 = Setup
When
2
press <Ctrl><Alt><D>.
Follow the instructions on the screen.
3
If a failure is reported, see "Hard Drive Problems" in your User's Guide.
appears in the upper-right corner of the screen,
appears in the upper-right corner of the screen,
appears in the upper-right corner of the screen,