Daily Use; Starting A Programme - ARTHUR MARTIN ASF9500LOX Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start a programme suitable for
the type of load and the degree of soil.
Using the detergent
A
B
30
20
CAUTION! Only use detergent
specifically designed for
dishwashers.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or tablets,
in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
C
Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.

Starting a programme

1. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
2. Close the appliance door.
3. Press Programme again and again
until the indicator of the programme
you want to select comes on.
The display shows the programme
duration.
4. Set the applicable options.
5. Press Départ to start the programme.
• The washing phase indicator
comes on .
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Départ Différé again and again
until the display shows the delay time
you want to set (from 1 to 24 hours).
The indicator of the selected programme
flashes.
3. Press Départ.
4. Close the appliance door to start the
countdown.
When the countdown is completed, the
programme starts and the washing phase
indicator comes on.
13

Publicité

Chapitres

Table des Matières
loading

Table des Matières